Add wireless codepad

To assign the wireless keypad to a desired smart lock, first go to the settings of the lock. 

Next click on"Wireless Keypad".

To add a new wireless keypad, click on "Add keypad".

In order for the wireless keypad to be recognised by the mobile phone, the configurationmode must be activated. This is the case when the LED (top right) on the device flashes green. If so, click on "Next".

If this is not the case, please tap on "The keypad does not flash".  You will then be asked to enter the code *529# on the keypad. After entering the code, the LED (top right) should now flash green.

Then click on "Next".

Note: If this does not work, you can also activate the keyboard by pressing the reset button (acoustic signal sounds).

To do this, unscrew the four screws on the back of the wireless keypad and remove the back cover. Then press the reset button.

Now you can select your keypad and give it a name. Then confirm with "OK".

The keypad is now connected to the selected lock and can unlock it with all passcodes you have created. To open the lock, enter a valid code and then press the (#) Unlocking – key.

Note: The lock can also be locked by pressing the (#) Unlocking – key for a long time (if passage mode is activated).

Attention: Also note that the wireless keypad should be within Bluetooth range of the lock!

Delete wireless codepad

Delete a single codepad

To delete a keyboard that is assigned to a lock, first click on "Settings" on the home page of the lock and then on "Wireless Keypad".

Now select the wireless keypad that you want to remove from the lock. Then click on "Delete" at the bottom and confirm the process by clicking "Delete" again.

Delete all codepads

To remove all keypads, first click on "Reset" in the top right-hand corner and then confirm by clicking "Delete" again. All keypads which were assigned to the lock are now deleted!